COLUMBIA
FIREPLACE MANTELS
Get a Quote

Making a Mantel From Your Own Tree

Yes, your own tree can become your mantel. The log has to make the trip to our mill near Columbia, where we saw the beam; our saw doesn't travel, and felling the tree is a job for a tree service, not for us. The two things to get right are the log, which needs a straight, sound section big enough for the beam you want, and the timing, because a beam sawn from a fresh log is wet and needs drying time before it goes over a fire.

Is the tree big enough?

A square beam is cut from the middle of the log, so the log has to be wide enough for the beam's corners. The minimum is the beam's diagonal, measured across the log's narrow end with the bark excluded:

Beam Diagonal (minimum log, inside bark)
6x6 about 8½ in
6x8 10 in
8x8 about 11⅓ in
8x10 about 12¾ in

For a 6x8, that's √(6² + 8²) = 10 inches. At that size, the corners would just touch the bark, so add a few inches for clean, square corners and for the pale sapwood if you want dark heartwood showing. In practice, a log 14 inches or more across the small end gives a good 6x8 or 8x8.

Measure the small end, not the big end. Trunks taper, and the beam has to fit at the narrow end too.

Is the log good enough?

A good mantel log is:

  • Straight for the length you need. A bow of more than an inch or two over the length means a smaller beam, or one with the curve cut through the grain.
  • Long enough. The length of the mantel, plus extra so we can trim checked ends after it dries. Ends usually check first.
  • Sound. Rot at the ends often runs further in. A hollow center rules out a beam from that section.
  • Free of metal, or at least honest about it. Yard trees often hold nails, fence wire, clothesline hooks and tree stand bolts. Tell us what you know, so we can find it before the saw does.

Big knots and limbs are character in a mantel, but a large knot on the front face of a beam is also where checks like to start.

Which trees make good mantels

The woods that make good mantel beams from the forest make good ones from the yard: black walnut, white oak, red oak, eastern red cedar, cherry, sycamore, ash and elm. Our wood species page compares how each looks and how heavy a beam will be.

Some yard trees, cottonwood for one, are too soft and too prone to warping to make a good beam. If yours isn't a mantel wood, we'll tell you.

Getting the log to our mill

  1. Get a tree service to fell it. Ask the crew to leave the trunk in one long, straight piece, cut a little longer than the mantel you want. Tell them before they start, or it may end up in firewood lengths.
  2. Measure and photograph it. Width across the narrow end, overall length, plus pictures of both cut faces and one of the full trunk.
  3. Send it all through our quote form, naming the tree if you can, and we'll say whether it will yield the mantel you want.
  4. Bring it to the mill. A mantel log is heavy. A 14-inch by 8-foot green white oak log holds about 8½ cubic feet of wood and weighs roughly 500 pounds or more, so it needs a trailer and a way to load it, like a tractor, a skid steer or the tree crew's equipment.

Do it soon after the tree comes down. A log left on the ground for months can stain, check deeply at the ends or start to rot, depending on the species and the season.

How long until it can go up?

Here's the honest part. A beam sawn from a fresh log is green: full of water, heavy, and certain to shrink and check as it dries. Air-drying goes slowly, by the old sawyer's rule about a year for every inch, so a 6- or 8-inch beam needs years to dry to its center.

You have three choices:

  • Wait. Stack the beam off the ground, out of the rain and sun, with air moving around all sides, and coat the ends to slow end checks. Bring it indoors for the last stretch before you hang it.
  • Hang it green, knowing what to expect. Many people do this with a family-tree mantel; they'd rather have it up now. Expect it to check, possibly twist slightly, and shrink a little across its height and depth. Mount it with rods or a cleat so it can move, not glued, and keep fires modest the first winter.
  • Go slimmer. A 4-inch-thick shelf dries in far less time than an 8-inch beam.

Our guide Will a solid wood mantel crack? explains why green beams check and how to keep it under control.

Why it's worth it

A tree that shaded your house or stood on the family farm for decades is more than wood. Cut into a mantel, it stays in the family and goes up over the fireplace, where everyone sees it. It's also a far better use of a good trunk than firewood.

Get a Mantel Quote

Share pictures of the trunk with its length and narrow-end width, and we'll tell you what kind of mantel it can become.

Get a Mantel Quote

A FOCAL POINT THAT FEELS LIKE HOME

Make the fireplace
your own.

Send the wall measurements and a photo. We’ll quote a mantel for your room.

Get a Quote