A mantel should run past the fireplace opening on both sides, stand out from the wall far enough to look solid, and hang high enough to meet fire code. On a masonry fireplace, the code keeps wood at least 6 inches from the opening and limits how far it can stick out within 12 inches of it, so a deep beam ends up at least 12 inches above the opening. Gas inserts and factory-built units follow their own manual.
Here's how to work out each dimension, then the five measurements we need to quote you a mantel.
Length: how far past the opening
Start with the fireplace opening, the hole the fire sits in, and the surround, the brick, stone or tile around it. The mantel should be at least as long as the opening, and almost always longer.
A common starting point is a mantel that runs a few inches past the surround on each side. On a wide stone wall that runs floor to ceiling, people often go longer, so the mantel spans a good share of the wall instead of looking like a shelf stuck in the middle. On a narrow chimney breast, keep a few inches of wall showing at each end so the mantel doesn't look crammed in.
A quick check: cut a piece of cardboard or painter's tape to the length you're considering and put it on the wall. Step back across the room. It's the easiest way to see whether 60 inches or 72 looks right.
Off-center and corner fireplaces take a judgment call. Center the mantel on the firebox, not the wall, so it lines up with the fire. If that leaves one end crowding a side wall, a door casing or a window, shorten the mantel until both ends have some breathing room.
Length doesn't change the weight per foot, but it does change the total. Every extra foot of a 6x8 white oak beam adds about 16 pounds.
Depth and thickness
Depth is how far the mantel sticks out from the wall. Beam mantels usually run 6 to 10 inches deep. Less than about 5 inches leaves little room for frames; more than 10 starts to look heavy over a small fireplace and puts more leverage on the mounting.
Thickness is the height of the front face. For a beam, 6 to 8 inches is typical. For a live edge shelf, 2½ to 4 inches. Taller fireplaces and taller walls carry a thicker mantel; a small firebox under a chunky 8x10 can look top-heavy.
A rule of thumb many builders use: match the mantel's scale to the fireplace, not the room. If the opening is small, go slimmer. If the chimney runs to a vaulted ceiling, go bigger.
Depth also decides how high the mantel has to go, which is the next section.
Mounting height
The height of a mantel is set by two things: the code clearance below it and how it looks on the wall.
Start by measuring from the floor to the top of the fireplace opening. On a masonry fireplace, any mantel deeper than 1½ inches has to sit at least 12 inches above that point. Add 12 inches to your measurement, and that's the lowest the bottom of a beam can go.
From there, it's a matter of looks. A mantel set close to that minimum feels anchored to the fireplace. A mantel set much higher can look like it's floating away from it, and it leaves less wall above for art or a TV. Our guide How high should a mantel be? works through examples for low, standard and raised hearths.
Code clearance for masonry fireplaces
For masonry fireplaces, the International Residential Code (section R1001.11, Exception 4) allows a wood mantel or trim on the fireplace front, with two limits:
- No combustible material within 6 inches of the fireplace opening.
- Within 12 inches of the opening, combustible material can project only 1/8 inch for each inch of distance from the opening.
Here's what the second rule allows:
| Distance from the opening | Most it can stick out |
|---|---|
| 6 inches | ¾ inch |
| 8 inches | 1 inch |
| 10 inches | 1¼ inch |
| Just under 12 inches | about 1½ inches |
| 12 inches or more | Not limited by this rule |
So a 6 to 10 inch deep beam sits 12 inches or more above the opening, and side trim within 12 inches has to stay nearly flat. Some inspectors read the 12-inch line strictly, so setting a deep mantel a little above 12 inches leaves no room for argument. You can read the code chapter on the ICC's site.
Codes are adopted locally and can be amended, so the building department that covers your address has the final word. If you're not sure whether your fireplace counts as masonry, ask them before you order.
Gas and prefab fireplaces: follow the manual
Gas inserts, gas log sets in a factory-built box, wood-burning prefab fireplaces and electric units are tested and listed by their makers. Their installation manual gives the clearances to a combustible mantel, often as a chart of mantel depth against height above the opening. Those numbers replace the masonry rule above, and they're sometimes larger.
Find the manual by the model number on the rating plate, usually inside the control door or on the firebox frame. If you can't find it, the maker's website usually has a copy. Send us the mantel clearance it lists, and we'll size the mantel to meet it.
A mantel heat shield, a metal deflector mounted under the mantel, can sometimes reduce the clearance on gas units if the maker allows it. Check the manual before relying on one.
TV above the mantel
A TV over a fireplace sits higher than ideal for viewing, and a mantel pushes it higher still. The fix is a slimmer mantel, hung near its lowest legal height, with a small gap to the TV. Check the TV maker's limits on heat, too.
Our guide Mantel and TV: heights that work together works through the numbers for a few common setups.
Five measurements to send us
- Opening width: across the fireplace opening, side to side.
- Opening height: from the floor to the top of the opening.
- Surround and wall width: the width of the brick, stone or tile, and of the wall the mantel goes on.
- The mantel you want: length, depth and thickness, even rough guesses.
- Wall and fireplace type: brick, stone, tile or drywall, and whether it's a masonry wood-burner, a gas insert, a prefab or electric.
Add a straight-on photo of the whole fireplace wall. If it's a gas or prefab unit, include the mantel clearance from its manual. Before you drill, read mounting a solid wood mantel.
Get a Mantel Quote
Send us the five measurements and a photo, and we'll reply with a mantel sized to your fireplace and a price.